English Turn Porcelain Pull Chain Toilet Specifications

19" 16 1/2" 8 1/4" 14" 12 1/2" 15 1/2" 15" 10" 15" Adjustable 7" 12" Rough In 28" 18" 6" Tank height is adjustable by cutting pipes. Mounts with bolts. Height of mounting bolts is adjustable. Flush pipe from wall is 4 1/2". Flush pipe is 1 1/4" outside diameter. Water supply pipe from wall is 2 1/2". Water supply pipe is 1/2" outside diameter.

English Turn Porcelain Pull Chain Toilet Parts List

The English Turn Porcelain Pull Chain High Tank Toilet is shipped in 3 cartons:

Tools Needed

Hacksaw or tube cutter, Phillips screwdriver, level, 1/4" drill bit, wrench, wax ring seal or plumbers putty.

English Turn Porcelain Pull Chain Toilet Installation Instructions

	Shut off water supply, disconnect plumbing, and remove existing toilet bowl.
	Install #413-HA tank handle assembly with chain to tank. Remove handle screw with Phillips screwdriver and remove handle. Remove the front trim ring by turning clockwise (this is a left-hand thread). Place assembly through the tank with washer on assembly (this should be inside the tank). Assemble front trim ring by turning counter clockwise. Put handle on spindle and attach with screw.
	Using a new wax ring seal (not furnished), or plumber's putty, mount the toilet bowl to the floor drain opening.
	To attach the tank to the wall, locate and drill holes in the wall approximately 80" above the floor. The holes should be 8" center to center. You may choose any height between 75" and 82". and later trim the flush pipe assembly. Use proper hardware to attach the tank to the wall. Large screws, toggle bolts or other fasteners can be used depending on the wall material. These parts are NOT furnished. Attach tank to wall and use level to check for evenness.
	Slide the #5552 slip nut up #5568 flush pipe and connect the slip nut to the #5560 outlet at the bottom of the tank. Do not forget washers.
	Place #5567 wall bracket against the wall at the height where the lip of the toilet seat cover will come in contact with the bracket. Tighten the 2 brass screws that are furnished and insert them into the wall bracket and attach to the wall.
	Insert #5570 flush elbow into the toilet bowl taking care to use rubber washers and slip nuts. Do not damage washer or strip nut.
	Insert #5569 supply pipe into tank and tighten carefully using white plastic nut.
	Insert toilet seat (not furnished).

NOTE: Angle stop valve and flange are not included.